Product Detailed Parameters
产品详细介绍
Performance Characteristics
1. Balanced Precision and Stability
The ±1% tolerance combined with a ±100ppm/℃ temperature coefficient means that across the full temperature range from -55℃ to +155℃, resistance drift remains within a reasonable range. It is suitable for applications requiring a certain level of signal accuracy but not ultra-high precision (such as ±0.1%).
2. Power Margin Requires Attention
The 100mW power rating is standard for the 0603 package. In practical use, derating is recommended (typically designing at 50%~70% of the rated power), i.e., keeping actual power dissipation per unit within 50~70mW to ensure long-term reliability.
3. Industrial-Grade Environmental Adaptability
The wide temperature range of -55℃ to +155℃ enables it to handle most industrial control, automotive electronics peripherals, communication equipment, and similar scenarios without concern for performance degradation under high or low temperature environments.
4. Positioning of Thick Film Technology
Thick film resistors are the most widely used process route among SMD resistors, offering low cost, stable supply, and a complete range of specifications. Compared with thin film resistors, they are slightly inferior in precision and noise, but for general-purpose resistance values like 10kΩ used in voltage division, biasing, and pull-up/pull-down applications, they are entirely adequate.
Typical Application Scenarios
10kΩ is an extremely high-frequency resistance value in electronic design. Common uses for this resistor include:
|
Application Scenario
|
Specific Function
|
|
Pull-up/Pull-down Resistor
|
Level definition for I²C bus, GPIO pins, reset circuits
|
|
Voltage Divider Circuit
|
ADC sampling front-end, power supply voltage detection
|
|
Current Limiting Resistor
|
LED indicator, optocoupler input side current limiting
|
|
Biasing Resistor
|
Transistor base bias, op-amp input bias
|
|
RC Filtering/Timing
|
RC low-pass filtering or delay circuits in combination with capacitors
|
|
Crystal Oscillator Circuit
|
Load or feedback resistor in certain crystal oscillator circuits
|
Selection and Usage Recommendations
-
Cross-Reference Compatibility: This model is essentially equivalent in parameters to Yageo RC0603FR-0710KL and Samsung RC1608F103CS (0603 10kΩ ±1% resistors), and can be evaluated as a domestic alternative.
-
Soldering Process: The 0603 package is suitable for reflow soldering. For manual soldering, control the iron temperature (recommended within 350℃) and soldering time to avoid damaging the end electrodes.
-
Storage Conditions: Tape & Reel packaging should be stored in a dry, light-protected environment. After opening, it is recommended to use within the specified workshop environment lifetime to prevent end termination oxidation affecting solderability.
-
Purchasing Notes: Tape & Reel packaging is typically ordered by full reel (commonly 4000~5000 pieces per reel). For small-batch prototyping, check whether partial-reel retail channels are available.